Nu-Link3-Pro
I. Development Environment Settings
| 1. | Install the preferred toolchain. Please make sure at least one of the toolchains has been installed : | ||||
| - | KEIL MDK Nuvoton edition – Full Cortex®-M | ||||
| - | IAR EWARM | ||||
| - | Visual Studio Code (VS Code) | ||||
| 2. | Download and install the latest Nuvoton Nu-Link Driver. Please install the Nu-Link USB Driver as well at the end of the installation. | ||||
| - | Download and install Nu-Link_Keil_Driver when using Keil MDK. | ||||
| - | Download and install Nu-Link_IAR_Driver when using IAR EWARM. | ||||
| - | Download and install Nuvoton NuMicro® Cortex®-M Pack when using VScode. | ||||
| 3. | Download and unzip the Board Support Package (BSP). | ||||
| 4. | Download and install Nuvoton tools | ||||
| - | ICP Programming Tool | ||||
| - | ISP Programming Tool | ||||
II. For hardware setup, please click the following link. Nu-Link3-Pro Hardware Connection
III. Related Features
| 1. | Develop and debug- Open and excute the project under the toolchain. | |||
| - Keil MDK | ||||
| - IAR EWARM | ||||
| - VSCode | ||||
| 2. | ICP Programming | |||
| - Online ICP Programming | ||||
| - Offline ICP Programming | ||||
| 3. | ISP Programming | |||
| - Online ISP Programming | ||||
| - Offline ISP Programming | ||||
| 4. | To use the ETM function, you need to make ETM related settings and then use the ETM to monitor the code, please click the following link for setting. ETM setting | |||
| 5. | For information on how to use the built-in MicroPython feature, please refer to the following link. MicroPython | |||
| 6. | For information on the logic analyzer function, as well as software download and usage instructions, please refer to the following link. PulseView Logic Analyzer | |||
|
|
||||
|
Nu-Link3-Pro Debugger/ Programmer User Manual | Microcontrollers | Development Tools | Drivers | Programmer Software | Nuvoton Official Forum | Nuvoton Official E-Store
|
||||