Nu-Link-Me/Nu-Link2-Me

Nu-Link-Me

The Nu-Link-Me is a simple debugger and programmer with debug and on-line programming function, only provided with the NuTiny development board, and can be used independently to develop NuMicro® family microcontrollers.

Nu-Link2-Me provides virtual COM port (VCOM) function to print out messages on PC.

Nu-Link-Me_1

Nu-Link2-Me

The Nu-Link2-Me is a simple debugger and programmer with debug and on-line/off-line programming function, only provided with the NuMaker development board, and can be used independently to develop NuMicro® family microcontrollers.

The on-board 16 Mbit SPI Flash allows it able to support off-line programming. 

Nu-Link2-Me provides virtual COM port (VCOM) function to print out messages on PC.

Nu-Link2-Me_1 Nu-Link2-Me_2

 

Name Feature Supported Device User Manual Hardware Resources
Nu-Link-Me A basic debugger/programmer, through the resistor to adjust SWD interface voltage :
• USB 2.0 FS to SWD interface
• SWD interface up to 12 Mbps
• On-line ISP firmware update : UART
• Hardware setting SWD interface voltage : 3.3 V, 5.5 V
• Virtual COM port
NuMicro® Family  - (Refer to NuMaker User Manual) -
Nu-Link2-Me A basic debugger/programmer, through the resistor to adjust SWD interface voltage :
• USB 2.0 HS to SWD interface
• SWD interface up to 12 Mbps
• On-line/off-line ISP firmware update : UART
• Hardware setting SWD interface voltage : 1.8V, 3.3 V, 5.0 V
• Virtual COM port
NuMicro® Family  - (Refer to NuMaker User Manual) -
This website uses cookies to ensure you get the best experience on our website. Learn more
OK