NuMaker-M031TC

Quick Start

1. Install the preferred toolchain. Please make sure at least one of the toolchains has been installed.
  - KEIL MDK Nuvoton edition M0 / M23
  - IAR EWARM
  - NuEclipse (GCC) ( Windows )
  - NuEclipse (GCC) ( Linux )
2. Download and install the latest Nuvoton Nu-Link Driver. Please install the Nu-Link USB Driver as well at the end of the installation.
  - Download and install Nu-Link_Keil_Driver when using Keil MDK.
  - Download and install Nu-Link_IAR_Driver when using IAR EWARM.
  - Skip this step when using NuEclipse.
3. Download and unzip the Board Support Package ( BSP ).
4. Hardware Setup
  (1) Open the virtual COM ( VCOM ) function by changing Nu-Link2-Me VCOM Switch No. 1 and 2 to ON.
   

  (2) Connect the ICE USB connector to the PC USB port through USB cable.
   

  (3) Find the “Nuvoton Virtual COM Port” at Device Manger.
   

5. Use the “Template” project as an example. The project can be found under the BSP folder.
  - M031_Series_BSP_CMSIS_V3.XX.XXX
    - SampleCode
      - Template
        - GCC
        - Keil
        - IAR
6. Open and execute the project under the toolchain. For detail setting, please refer to the NuMaker-M031SD User Manual.
7. User can see the result in the ternimal window on PC.
 

 

Resources

User Manual | Microcontrollers | Software Development Tool | Driver (BSP) | Programmer | Nuvoton Official Forum | Nuvoton eStore