FAQ
- M051 Base Series(95)
- M0518 Series(97)
- M0519 Series(43)
- M0564 Series(1)
- Mini51 Base Series(90)
- Nano100/102 Base Series(101)
- Nano103 Base Series(10)
- Nano110/112 LCD Series(100)
- Nano120 USB Series(111)
- Nano130 Advanced Series(110)
- NUC029 Series(94)
- NUC100/200 Advanced Series(102)
- NUC120/122/123/220 USB Series(116)
- NUC121/125 Series(1)
- NUC126 USB Series(2)
- NUC130/230 CAN Series(103)
- NUC131/NUC1311 CAN Series(98)
- NUC140/240 Connectivity Series(114)
Products
Applications
Function
+
FAQ
How many pull-down resistors are needed to keep I/O low when I/O power-on is initially configured to Quasi-High? Issue Date：2018-03-08
If the microcontroller’s (MCU’s) GPIO is configured to Quasi-High by default. When the MCU is powered on, the I/O will keep High until I/O mode or output logic is changed.
If the component outside the MCU needs to keep logical low, there may be problems with the transient logical high when the MCU is powered on. This problem can be figured by a pull-down resistor to keep the I/O in a logical low condition.
Notice that, when a pull-down resistor is added to the I/O, if the resistance is too large, the voltage may not be reduced; if the resistance is too small, the leakage current may increase.
To add a pull-down resistor in the application, a value of 1kΩ can be used in the NuMicro® family MCU to meet the need.
| Products: | Microcontrollers ,8bit 8051 MCUs ,Arm Cortex-M0 MCUs ,Arm Cortex-M4 MCUs |
|---|---|
| Applications: | |
| Function: | Peripherals,I/O,GPIO |