Online Support

Featured Products

Featured Applications

The NuMicro® M484 USB HS OTG series is a high performance, low power microcontroller powered by the Arm® Cortex®-M4F core with DSP extension. It can run up to 192 MHz with 175 µA/MHz dynamic low power consumption. The 512/ 256 KB embedded dual bank Flash memory supports OTA (Over-The-Air) firmware upgrade, and the 160/ 96 KB embedded SRAM includes 32 KB cache to speed up external SPI Flash code execution. The factory pre-loaded bootloader delivers Secure Boot functionality to provide the code integrity check in embedded Flash memory. The built-in Secure Protection ROM provides a safe space for saving confidential program or data. One-Time Programmable ROM is also included for product life-cycle management.

The NuMicro® M484 USB HS OTG series supports operating voltage from 1.8V to 3.6V, and industrial operating temperature from -40°C to 105°C. It is integrated with 2 sets of USB 2.0 interface with op-chip full speed and high speed OTG PHY. Package type includes LQFP64 and LQFP128.

Target Application:
USB Adapter, USB Sensor Hub, etc.

Key Features:

Core
  - Up to 192 MHz Arm® Cortex ®-M4F delivering 1.25 DMIPS per MHz
  - DSP instruction set
  - Memory Protection Unit (MPU)
   
Memory
  - 512/ 256 KB zero-wait state Flash memory
  - 160/ 96 KB RAM, including 32 KB external SPI Flash cache
  - 4 KB Secure Protection ROM
  - 2 KB One-Time-Programmable ROM
   
Cyclic Redundancy Calculation Unit
   
16-ch Peripheral DMA Controller
   
External Bus Interface
  - LCD parallel interface, i80 mode
   
Clocks
  - 4 to 24 MHz crystal oscillator
  - 32 kHz oscillator for RTC
  - Internal 12 MHz RC oscillator
  - Internal 10 kHz RC oscillator
  - Internal PLL up to 480 MHz
   
RTC
  - 80 bytes of battery-powered backup registers
   
Timer & PWM
  - Four 32-bit timers
  - Twelve Enhanced PWM with twelve 16-bit timers
  - Twelve Basic PWM with two 16-bit timers
  - One 24-bit count-down SysTick timer
  - One watchdog timer
  - One window watchdog timer
Analog Peripheral
  - One 12-bit, up to 16-ch 5MSPS SAR ADC
  - Two 12-bit, 1 MSPS DAC
  - Two rail-to-rail comparators
  - Three operational amplifiers
   
Communication Interface
  - Up to 6 low power UART interfaces (17 Mbps), including 2 LIN interfaces
  - Up to 3 ISO-7816 interfaces (3.4 MHz), supporting full duplex UART mode
  - Three I²C interfaces (Up to 3.4 Mbps)
  - One SPI Flash interface (Up to 96 MHz) supports quad mode
  - One Quad-SPI interface (Up to 96 MHz)
  - Up to 4 SPI/ I²S interfaces (SPI up to 96 MHz, I²S up to 192 kHz/16-bit)
  - One I²S interface (192 kHz/32-bit)
  - Two USCI interfaces, supporting configurable UART/ SPI/ I²C
  - Two Secure Digital Host Controllers (50 MHz)
   
Control Interface
  - Two quadrature encoder interfaces
  - Two 24-bit, 3-ch input capture timer/counter units
   
Advanced Connectivity
  - USB 2.0 high speed device/ host/ OTG controller with on-chip PHY
  - USB 2.0 full speed device/ host/ OTG controller with on-chip PHY
     
Operating Characteristic
  - Voltage range: 1.8V to 3.6V
  - Temperature range: -40°C to +105°C

Share

Enter the Email address you like to share*
Your email*
Your name*
Validate Code*
Part No. Check Disty Flash SRAM Data Flash ISP ROM PDMA I/O Timer UART ISO-7816-3 SPI I2C CAN LIN EBI I2S/ AC97 USB OTG USB Host USB Device PWM Comparator DAC ADC Audio Codec Touch Key RTC Tamper Detect (pin) Voltage Adjustable Interface ISP/ICP/IAP Package Operating Temp. Range (¢FXC ) Status SD Host Ethernet MAC Camera Interface QEI OP Amp. Crypto
M484KIDAE Check Disty None 512K 160K Configurable 4K 16 100 4*32-bit 8 3 8 5 - 2 5 FS+HS - - 24*16-bit 2 2*12-bit 16*12-bit - - Y 6 Y ISP, ICP, IAP LQFP128 -40 to +105 Mass Production 2 - - 2 3 -
M484SGAAE Check Disty None 256K 96K Configurable 4K 16 44 4*32-bit 8 3 8 5 - 2 5 HS - - 24*16-bit 2 2*12-bit 16*12-bit - - Y 1 Y ISP, ICP, IAP LQFP64 -40 to +105 Mass Production 2 - - 2 2 -
M484SGAAE2U Check Disty None 256K 96K Configurable 4K 16 44 4*32-bit 8 3 8 5 - 2 5 FS+HS - - 24*16-bit 2 2*12-bit 16*12-bit - - Y 1 Y ISP, ICP, IAP LQFP64 -40 to +105 Mass Production 2 - - 2 2 -
M484SIDAE Check Disty None 512K 160K Configurable 4K 16 44 4*32-bit 8 3 8 5 - 2 5 HS - - 24*16-bit 2 2*12-bit 16*12-bit - - Y 1 Y ISP, ICP, IAP LQFP64 -40 to +105 Mass Production 2 - - 2 2 -
M484SIDAE2U Check Disty None 512K 160K Configurable 4K 16 44 4*32-bit 8 3 8 5 - 2 5 FS+HS - - 24*16-bit 2 2*12-bit 16*12-bit - - Y 1 Y ISP, ICP, IAP LQFP64 -40 to +105 Mass Production 2 - - 2 2 -

User Feedback

Please rate our website
Email
Name*
Validate Code*

微信扫一扫,关注新唐MCU。

Login myNuvoton

to stay informed of any changes to the documents you download.
If you don't want to login, just close this page and download directly.